Set Ntp Server; Set Dst; Set Rs-232 - HIKVISION DS-2TD2637T-7/P User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
4. Choose one time synchronization method.
- Select Set Time, and manually input or select date and time from the pop-up calendar.
- Check Sync. with computer time to synchronize the time of the device with that of the local
PC.
5. Click Save.

10.10.2 Set NTP Server

You can use NTP server when accurate and reliable time source is required.
Before You Start
Set up a NTP server or obtain NTP server information.
Steps
1. Go to Configuration → System → System Settings → Time Settings .
2. Select Time Zone.
3. Click NTP.
4. Set Server Address, NTP Port and Interval.
Note
Server Address is NTP server IP address.
5. Click Test to test server connection.
6. Click Save.

10.10.3 Set DST

If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → DST .
2. Check Enable DST.
3. Select Start Time, End Time and DST Bias.
4. Click Save.

10.11 Set RS-232

RS-232 can be used to debug device or access peripheral device. RS-232 can realize communication
between the device and computer or terminal when the communication distance is short.
Before You Start
Connect the device to computer or terminal with RS-232 cable.
80