Set Snmp; Set Image And Video Library - HIKVISION iDS-TCD403-BI User Manual

Network Traffic Camera (for Traffic Flow Camera) User Manual
If you use EAP-MD5, the authentication server must be configured. Register a user name and
password for 802.1X in the server in advance. Enter the user name and password for
authentication.
EAPOL Version
The EAPOL version must be identical with that of the router or the switch.
4. Enter User Name and Password registered in the server.
5. Confirm the password.
6. Click Save.

6.5 Set SNMP

You can set the SNMP network management protocol to get the alarm event and exception
messages in network transmission.
Before You Start
Download the SNMP software and manage to receive the device information via SNMP port.
Steps
1. Go to Configuration → Device Configuration → System → SNMP .
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
• The SNMP version you select should be the same as that of the SNMP software.
• Use different versions according to the security levels required. SNMP v1 is not secure and
SNMP v2 requires password for access. SNMP v3 provides encryption and if you use the third
version, HTTPS protocol must be enabled.
3. Set the SNMP parameters.
4. Click Save.

6.6 Set Image and Video Library

Set the interaction parameters of the device consistent with those of the image and video library
platform via the image and video library (1400) protocol, and register the device on the platform.
When the device generates alarm signals, the alarm information will be sent to the platform.
Steps
Note
The function varies with different models. The actual device prevails.
1. Go to Configuration → Device Configuration → System → Image and Video Library .
2. Check Enable.
3. Set the parameters such as the device ID, user name, password, etc.
31