Wan Connections; 4-Port Ethernet Switch Connections - Teldat Regesta Smart PRO Installation Manual

Hide thumbs Also See for Regesta Smart PRO:

Table of Contents

Teldat S.A.

4.2.2 WAN connections

The Regesta Smart PRO features a single Ethernet COMBO Gigabit interface designed for WAN connections. This

interface includes two connectors: an SFP connector for optical links and an RJ-45 for 10/100/1000 Base-T links. It is

important to note that these connectors cannot be used simultaneously. Additionally, the interface operates inde-

pendently from the switch, if present, and can be managed like any other interface.

Be sure to carefully observe the labeling to avoid confusion with other ports:

WAN and SFP connectors

Fig. 11:

4.2.2.1 Laser information

Warning

Laser Radiation. Do not use optical instruments directly or without proper protection. CLASS 1 LASER

PRODUCT.

The SFP modules that will be installed in the card socket must be class 1 devices and should comply

with the IEC/EN 60825-1:2007 standard.

Certain models of the Regesta Smart PRO router are equipped with a 4-port 10/100/1000 Base-T switch that allows

for automatic MDI/MDIX connection to a local area network (LAN).

Regesta Smart PRO

Please ensure that the SFP transceivers you choose adhere to the following regu-

lations:

• Class 1

• IEC/EN60825-1:2007 2nd Edition or any later European standard

• FCC 21 CFR Chapter 1, Subchapter J (in accordance with FDA and CDRH re-

quirements)

• 2014/30/EU EMC Directive and the 2014/35/EU Low Voltage Directive for the

application of CE marking

• UL and/or CSA registered components for use in North America

• 47 CFR Part 15, Class A

4 Connecting the Router

Table of Contents

Do you have a question about the Regesta Smart PRO and is the answer not in the manual?