Advertisement
Silvia PID Installation Guide
Part B
Version 96-2.04
Step B8 – If you need to remove the collar
Once the collar has been locked tightly into place, removing it requires disengaging the
toothed gripping mechanism.
Generally, disengaging the teeth can be accomplished by sliding a thin sheet of cardboard
or plastic (credit card thickness) between the collar and the controller body. The large
plastic wire ties that are included in your kit are particularly effective for controllers
whose grips are located on the sides.
(The grips on the Watlow 96 controllers may be disengaged by squeezing together the
adjustment screws on the top and bottom of the controller.)
For more information on suggested methods of removing a locked collar, please consult
the users' guide for your controller, included on the CD in your kit.
Step B9 – Fasten enclosure to Silvia
Once you have completed connecting the controller wiring and have installed the
controller in the enclosure, it all needs to be mounted onto the side of Silvia.
Fasten the black L-bracket in your kit to the side of the stainless steel enclosure using
four (4) of the included #6 machine screws (remove any paper or plastic protective covers
on the acrylic at this time). Be careful not to over tighten so that you do not strip the
threaded holes that are in the side of the enclosure.
Locate the four (4) adhesive mounting pads included in your kit. Peel the backing on one
side and stick each pad to the L-bracket. The longest two pads should be located on the
shorter (upper, horizontal) leg of the L and should be positioned so that they cover the
heads of the screws that were used to fasten the bracket
to the enclosure.
The remaining two pads should be located on the longer
(lower, vertical) leg of the L. One should be near the
end (bottom) of this leg and one should be approx. ¼ of
the way down from the corner of the L. Do not omit
either of these pads – they serve an important function
in maintaining the correct positioning of your
enclosure.
(Note: in the photo at right, the paper protective cover
has not been removed from the acrylic. You should
remove any paper or plastic covering from your bracket
prior to bonding the pads.)
Once the pads are fastened to the L-bracket with
adhesive, do a trial fit by holding the assembly in place
Page B-6
Copyright © 2006, 2008 MLG Properties, LLC
Advertisement
