Advertisement
Silvia PID Installation Guide
Part A
Version 2.04
Step A13 – Install splitters on main power switch
Locate the main power switch for Silvia. The top terminals on the back of this switch are
going to be used to provide switched high voltage power for the digital controller. In the
photo below, the spade connectors for the red and black wires are the ones we will be
using (the yellow wire is for the switch lamp and will not be disturbed). Your Silvia may
use different colored wires.
Before you remove these wires, make some notes for yourself, or draw a sketch. Note
the locations and colors of the wires so that you are sure to get them back on the correct
terminal. Since models have changed over the years, you cannot necessarily rely on the
photos in this guide.
Carefully loosen the push-on connectors by gently wiggling back and forth while pulling
directly away. A flat bladed screwdriver (see below – screwdriver next to left terminal),
placed in the gap and gently twisted, can be used to help pry the connectors loose.
Copyright © 2006, 2008 MLG Properties, LLC
Page A-15
Advertisement
