Advertisement
Silvia PID Installation Guide
If you have a steam control package with your kit (only available for selected
controllers), you will have two (2) yellow control wires in addition to the wires
described above. There will also be an additional rubber grommet provided with the
steam package. Follow the same procedure as described above and route these 2
yellow wires through the base using an empty hole.
After you have routed the wires through the grommets, pull them gently out to almost
their fullest length, being careful not to pull anything loose. Assuming you will be
installing your digital controller on the left (facing the front of Silvia) side, then pull the
ends of the wires between the 2 rubber feet on the left side of Silvia's base, then up the
outside of the machine to the approximate position of the controller.
Copyright © 2006, 2008 MLG Properties, LLC
Part A
Version 2.04
Page A-29
Advertisement
