Advertisement
Silvia PID Installation Guide
Once you have the internal wiring secured, insert the wires into the black split loom cable
sheath provided. Starting at the bottom of the controller, insert wires through the split in
the sheath, working your way towards the grommets where the wires enter the bottom of
Silvia. The sheath may be trimmed to length, if necessary, with scissors.
Locate the white cable clamp, #10 screw, lock washer, flat washer, and nut in your kit.
Pass the screw through the hole in the clamp, and then up through one of the existing
holes in the pump compartment on the bottom of Silvia (see photo looking up from below
at the outside of the pump compartment, below). On the inside of the pump
compartment, place the flat washer, then lock washer, then nut on the threaded end of the
#10 screw. Tighten the screw with a Philips head screwdriver, while holding the nut with
your needle nose pliers or a small wrench.
Step B11 – Re-install Silvia's panels
Once the wiring is tidied up, return Silvia to an upright position and carefully reinstall
the:
• Splash panel
• U-shaped rear panel
• Top panel
Hopefully, you have managed to keep all of the screws together in your Jello cup. We
caution to not get in a hurry here, even though you are close to the end. Remember, the
panels are easy to scratch or bend, so take your time.
Be careful not to pinch any wires as you replace the panels. Make sure you have
removed all of your tools, bits of wire ties that have been trimmed off, or any other
foreign items that may have found their way inside.
Step B12 – Secure the external cable to L-bracket
When the enclosure, with controller, is installed, it should look like the following photos
(note that the photos may depict a different model controller and a different size
enclosure, but the mounting procedure is the same for all models):
Copyright © 2006, 2008 MLG Properties, LLC
Part B
Version 96-2.04
Page B-9
Advertisement
