Advertisement
Silvia PID Installation Guide
Part B
Version 96-2.04
to see exactly where you want the enclosure to be located on Silvia's side. (We
recommend that you position the vertical leg of the L on the black iron frame so that it
blends in as much as possible).
When you have decided on the final position of the enclosure, peel the plastic off the
pads, exposing the adhesive. Then simply stick the enclosure and L-bracket assembly
onto Silvia.
The choice of reclosable fasteners in this kit, as opposed to simple double-stick pads, is
so that you can make minor adjustments to the position after it has been initially
mounted. If you need to do this, peel the halves of the pads apart slowly so that you do
not bend or break anything in the process.
We do not recommend mounting without using the L-bracket. If you do this, then
over time the fasteners and adhesive will stretch and give a little, allowing the enclosure
to lean down a little. The L-bracket is intended to prevent this.
If you need to "unstick" the adhesive pads from either the bracket or from Silvia, we have
found citrus-based solvents to be very effective. In particular, we use Goo Gone
(www.magicamerican.com) in our shop and have found that it does an excellent job in
completely removing any glue residue and does not damage either the stainless steel
panel on Silvia or the acrylic of the L-bracket. Goo Gone is available in many retail
outlets.
Page B-7
Copyright © 2006, 2008 MLG Properties, LLC
Advertisement
