Advertisement
Silvia PID Installation Guide
Part B
Version 96-2.04
Locate the 2 large black wire ties provided in your
kit. The ties should be routed between the black
acrylic L-bracket and the iron frame of Silvia.
Before tightening the ties, push the cable loom up
and compress it tightly against the underside of
the enclosure (against the rubber grommet). Then
tighten and trim these ties as shown to secure the
cable loom and wires.
There is no need to over tighten these ties. The
appearance of your installation will be much
better if you do not "squash" the cable loom. A
snug fit that does not flatten the sheath is best.
Fastening the cable with these ties serves two
purposes. In addition to helping make a neat
wiring job, the ties also greatly reduce the stresses
on the wiring and its connections to the enclosure
and controller. We strongly recommend that
you not omit these ties.
Page B-10
Copyright © 2006, 2008 MLG Properties, LLC
Advertisement
