Advertisement
Silvia PID Installation Guide
Part B
Version 96-2.04
Step B7 – Clamp wires and install covers
Next, perform a trial fit of the bottom cover (the one with the wires running through the
grommet). At this time you may find it necessary, or desirable, to adjust the amount of
wire passing through the grommet. Once you have the proper amount of wire passing
through the grommet and into the enclosure, tightly fasten one of the small wire ties in
your kit around the wires to act as a clamp (see below). Note: the clamp should be on
the inside of the cover. Its job will be to prevent the wires from being pulled away from
the enclosure.
Once the wire tie/clamp is fastened securely, put the top and bottom covers on the
enclosure using the screws provided. Again, do not overtighten these screws.
Photo at right shows controller in the
installed position, with mounting collar in
proper location, locked in place. Again,
please note that your controller model may
be different from that shown. Please rely
on the specific wiring instructions for your
controller, not this photo.
Page B-5
Copyright © 2006, 2008 MLG Properties, LLC
Advertisement
