Advertisement
Silvia PID Installation Guide
Part B
Version 96-2.04
Step B10 – Tidy up the wiring
At this point, the enclosure should be mounted on the side of Silvia and you should have
a fair amount of excess wire between the bottom of the enclosure and the pump
compartment (the wires in your kit are intentionally a little long). The pump
compartment should still be open and accessible.
Carefully lay Silvia down on her right side, so
that the controller and enclosure are "up" and
the front of Silvia is to your right. (Obviously,
you will have to reverse this if you chose a
right side mount for your controller). Perform
a trial routing of the wires in order to
determine the proper lengths for your
installation. Then push the excess wire back
into the pump compartment.
Inside the pump compartment, make a small
loop with the excess wires, and secure
everything using the small black wire ties
provided. Silvia's power cable makes a very
good anchor for securing and routing your
new wires.
Study the photos for what we consider to be a
good way to route and secure your wiring.
Page B-8
Copyright © 2006, 2008 MLG Properties, LLC
Advertisement
