Rancilio Silvia PID Kit Manual page 50

Silvia PID Installation Guide

Part S

Version 96-1.01

Part S – Install Steam Control Package

Step S1 – Install relay

At this point, you should have already installed all of the wiring required for a basic PID

installation. You should have completed steps A1 through A16.

Your machine should still be unplugged, and you should not have completed the step of

running your wires through the base of the machine in the pump compartment.

Locate the small "ice cube" relay in your kit. It will already have 4 wires connected to it

on the proper terminals. Also locate the small adhesive pad included with the steam

package.

Use the adhesive pad to fasten the relay above and slightly to the right of the SSR that

you have already installed. See photo below.

The tabs on the relay should be pointing to the left as shown.

Step S2 – Remove front cover

Unless you have remarkable skills and long fingers, it will be necessary to partially

remove the front cover from Silvia in order to gain access to the steam switch. First,

locate and remove the screw that secures the base panel of the front cover to the brass

brew group. See photo below:

S-1