Advertisement
Silvia PID Installation Guide
Part A
Version 2.04
Once you have both splitters fully seated on the spade terminals, you should reinstall
Silvia's main power wires (the ones you removed a few minutes ago). Be sure to get
them back on the same side they came from. Slide them carefully onto the lower half
of the new splitters you just installed. Go easy when you reinstall these wires as the
splitters are easily bent. Gentle rocking back and forth will help them slide into place.
Be sure they are fully seated.
When you have completed this step, your installation should look very much like the
picture below (keeping in mind that, depending on the age of your Silvia, the wire
coloring may not be identical).
Copyright © 2006, 2008 MLG Properties, LLC
Page A-18
Advertisement
