Table of Contents
Advertisement
Nova430e Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide
3.3.1 Install on Pole
The following explains how to install the eNB on a pole.
Check to ensure the diameter of the pole is in the range of 1.6 in–2.8 in (40 mm–70 mm). The position of
the eNB on the pole should be at least 47 in (120 cm) in height. Follow the steps below to install the eNB
on a pole.
1. Unscrew the four nuts on the pole bracket. Slide the two omega clamps to the left, and then turn
them up or down (Figure 3-5).
Figure 3-5: Omega Clamps
2. Place the pole bracket on the pole and turn the two clamps to the proper position as shown in
Figure 3-6. Fasten the four nuts with a wrench.
Figure 3-6: Attach Bracket to Pole
18
Advertisement
Table of Contents
