Table of Contents
Advertisement
NOTE: The eNB may adopt different models of GPS antenna, so the GPS antenna may not the same
as above figure. But the installation steps that fix it on the eNB is the same.
2.4
Weatherproofing
To protect the connection points from weather and climate, clean each connection point
before installing cold shrink tubes, per the following figure.
1.
Insert the cable into the cold shrink tube.
2.
Tighten the connector.
3.
Push the cold shrink tube to the top joint, and pull out the strip.
4.
Ensure the cold shrink tube is tightly fitted with the connection.
2.5
Install on Pole
Check to ensure the diameter of the pole is in the range of 1.6 inches to 3.9 inches
(40mm to 100 mm). The position of the RRU on the pole should be at least 47 inches
(120 cm) in height.
The brackets have been pre-assembled in manufacturing before packing. It includes two
parts, one is pre-assembled on the back of the device. The other one is for pole
mounting or wall mounting, as shown in Figure 2-2.
Figure 2-2 Pre-assembled Device
9
Advertisement
Table of Contents
