Figure 3-3: GPS Antenna Installation
After assembling the GPS antenna, the connector must be waterproofed with all-weather electrical
tape and mastic tape. Refer to
3.3 Install eNB on Pole or Wall
3.3.1 Install on Pole
The eNB mounting bracket is assembled in manufacturing before packing. The only action required
by the installer is to attach the assembly to the pole.
Check to ensure the diameter of the pole is in the range of 1.6–2.8 in (40–70 mm). The position of
the eNB on the pole should be at least 47 in (120 cm) in height. Follow the steps below to install
the eNB on a pole.
1. Unscrew the four hex nuts of the assembled bracket. Slide the two omega clamps to the
left, and then turn them up or down (Figure 3-4).
Figure 3-4: Omega Clamps
2. Attach the bracket to the pole, considering the height requirements described above. Fit
the threaded rod of the bracket to the pole, and then turn the two clamps to the proper
position as shown in Figure 3-5. Fasten the four hex nuts with a Phillips-head screwdriver.
section
2.5.
17