Install On Pole; Figure 3-3: Place Bracket On Pole; Figure 3-4: Tighten Nuts - Baicells Nova430i Installation Manual

Nova430i Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide

3.2.1 Install on Pole

The following explains how to install the eNB on a pole.
Check to ensure the diameter of the pole is in the range of 1.6 in–2.8 in (40 mm–70 mm). The position of
the eNB on the pole should be at least 47 in (120 cm) in height. Follow the steps below to install the
Nova430i eNB on a pole.
1. Place the pole mounting bracket against the pole (Figure 3-3).
NOTE: The arrow must be pointing upward.

Figure 3-3: Place Bracket on Pole

1. Assemble the two omega clamps and tighten the four nuts on the back of the bracket (Figure 3-4).

Figure 3-4: Tighten Nuts

15