Page 2
About This Document This document describes the configuration of the LteTurbo CPE for EG8015Q-M11. It is a guide that how to configure the device after its installation completes. Copyright Notice Baicells Technologies Co., Ltd., copyrights the information in this document. No part of this document may be reproduced in any form or means without the prior written consent of Baicells Technologies Co., Ltd.
Menu Configuration Overview ....................1 Installation ........................1 Part & Materials ......................1 Led ..........................2 Login Web Client ......................5 Web Client Environmental Requirements ............... 5 Connect Web Client to CPE ..................5 Set Up Client Computer .................... 5 Log In ..........................
Page 4
General VPN ......................16 OpenVPN ........................17 System........................18 NTP ........................... 18 Account ........................18 Dynamic DNS ......................19 WEB Setting ......................19 TR069 ........................20 FTP Auto Upgrade ....................20 SNMP ........................21 Restore/Update ......................21 Ping Watchdog ......................22 8.10 SAS ..........................
1. Configuration Overview The Baicells LteTurbo CPE is loaded with its own GUI for configuring its operating parameters. You can log in to the GUI either locally through the Local Maintenance Terminal (LMT), which is an Ethernet port, or remotely via IP address. You can also use the Baicells Operations Management Console (OMC) to configure the CPE;...
Power Cable PoE Power Adaptor You will need standard tools, Ethernet cable, ground wire, and RJ-45 connectors for installing and connecting the outdoor unit. The CPE has 10 lights, divided into 6 groups according to the function: wifi signal light, lte signal light, power light, sim light, lan light, miu light (see figure below).
Page 7
Wifi signal light Arc logo ,Three lights indicate wifi signal strength according to the number of lights, full light indicates strong signal; full out when not connected Lte signal light Vertical logo , Three lights indicate lte signal intensity according to the number of lights, full light indicates strong signal;...
Page 8
Miu light Reserved Note: The status of the lamp is meaningless during the start-on process, and wait for the start-on (5 minutes) before checking the LED status.
3. Login Web Client Web Client Environmental Requirements Table 3-1 describes the requirements on computer of the client. Table 3-1 Environmental Requirements of the Client Item Description Above Intel Core 1GHz Memory Above 2G RAM Hard disk No less than 100 MB space available Operating system Microsoft: Windows XP, Windows Vista or Windows7 ...
Page 10
Figure 3-1 Internet Protocol Version (TCP/IPV4) Select either “Obtain an IP address automatically” or “Use the following IP address”: If “Obtain an IP address automatically” selected, go directly to step 7 If “Use the following IP address” selected, follow step 5 ~ step 7 ...
Log In Open a web browser, and enter http://192.168.150.1, as shown in Figure 3-1. Figure 3-1 GUI Login Input user name, password, and click “Login”. The homepage is given in Figure 3-2. Default user/password : admin/admin Figure 3-2 GUI Homepage NOTE: The information may vary by product type or software version.
Page 12
The status information area displays the WLAN connection status, rate statistics, LAN port connection status, and a list of connection devices.
4. Network Setting LAN Settings Config Lan IP and DHCP params WAN Settings Wan Interface : support AUTO, LTE, WIFI, and ngmwan Network Mode : support NAT and L2...
9. Regulatory Compliance FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.