Nova430e Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide
NOTE: For all GUI menus and fields, refer to the following documents on the Baicells website:
Baicells.com > Resources >
•
CloudCore Configuration and Network Administration Guide
•
Atom CAT4 CPE Configuration Guide
•
Atom CAT6/CAT15 CPE Configuration Guide
•
4G LTE eNodeB Configuration Guide – BaiBLQ
•
Carrier Aggregation and Dual Carrier/Split Mode Configuration Guide
•
HaloB Solution User Guide
•
SAS Deployment Guide
3.7.1 Launch the eNB GUI
Follow the steps below to connect to the Nova430e GUI.
Step 1:
Use an Ethernet cable to connect the eNB WAN/PoE+ port to the local Network routed to
the Internet. The DATA interface is set to Dynamic Host Configuration Protocol (DHCP)
client by default.
Optionally, you can plug a Personal Computer (PC) directly into the eNB MGMT port. On
your PC you will need to assign a static IP address within the Management (MGMT)
subnet. The default IP address for the MGMT interface is http://192.168.150.1/24.
Step 2:
Open a Web browser and enter the following IP address: http://192.168.150.1.
Step 3:
At the login screen (Figure 3-16), enter the default username (admin) and password
(admin) and click on Login to open the home page.
Figure 3-16: GUI Login
Documents.
26