Nova430e Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide
Figure 3-20: LAN Config Tab
Table 3-1: WAN/LAN/VLAN
Field Name
WAN/LAN Config Tab
Connect Type Pane
Connect Type
WAN Config Pane
Index
WAN Name
IP Access Mode
Option60
Description
Used to select the type of connection for the eNB:
•
Copper: RJ-45 electrical interface
•
Fiber: optical fiber interface
The connection type is based on the eNB model. If the eNB doesn't support
optical ports, the value must be set to Copper.
The WAN index number, which is automatically generated. The eNB supports
up to four WAN interfaces.
The WAN Name is automatically generated.
Used to select the desired interface protocol to be used by the WAN
interface:
•
DHCP: only the Option60 parameter needs to be configured if DHCP is the
interface protocol selected.
•
Static IP
•
IPv6 DHCP
•
IPv6 Static IP
Used to differentiate between different terminals when IP Access Mode is set
to DHCP. Range is 0–64 digits.
30