Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide
3.3 Install eNB on Pole or Wall
3.3.1 Install on Pole
The eNB mounting bracket is assembled in manufacturing before packing. The only action required by the
installer is to attach the assembly to the pole/wall bracket.
Check to ensure the diameter of the pole is in the range of 1.6–2.8 in (40–70 mm). The position of the eNB
on the pole should be at least 47 in (120 cm) in height. Follow the steps below to install the eNB on a pole.
1. Unscrew the four bolts of the assembled pole bracket. Slide the two omega clamps to the left, and
then turn them up or down (Figure 3-4).
Figure 3-4: Omega Clamps
2. Attach the pole bracket to the pole, considering the height requirements described above. Fit the
threaded rod of the bracket to the pole, and then turn the two clamps to the proper position as
shown in Figure 3-5. Tighten the four bolts with a wrench.
Figure 3-5: Attach Bracket to Pole
18