Related Manuals for Baicells Nova430i
Summary of Contents for Baicells Nova430i
- Page 1 Nova430i Outdoor 4x250mW eNodeB Quick Guide P/N: 1701000170 Document version: 02 All rights reserved © Baicells Technologies Co., Ltd.
-
Page 2: Product Overview
5, 10, 15, or 20 MHz bandwidth. Using a Nova430i in DC mode simplifies and streamlines the deployment of split sectors. In addition to having the option to operate Nova430i in either CA or DC mode, HaloB (an embedded MME option) comes as a default feature in the base software. Baicells's patented HaloB solution migrates the necessary core network functions to the eNB. - Page 3 Interface Name Description RJ-45 interface (FE/GE) Used for power supply, debug or data backhaul. PoE++, complied with IEEE 802.3bt standard Reserved optical interface. The Nova430i interface indicators are described in Table 1-2. Table 1-2 Nova430i Interface Indicators Identity Color Status Description...
-
Page 4: Technical Specification
Identity Color Status Description Slow flash: 1s on,1s off CELL2 is in activated. Steady On Hardware alarm No alarm Technical Specification 1.4.1 Hardware Specification Item Description LTE Mode LTE TDD LTE Frequency Band48, and partial band42,band43 Channel Bandwidth 5MHz, 10MHz, 15MHz, 20MHz per carrier Output Power 24 dBm per antenna Receive Sensitivity... -
Page 5: Software Specification
1.4.3 Software Specification Item Description LTE Standard 3GPP Release 15 2x20 MHz: SA1: DL 2x80 (160)Mbps, UL 2x28 (56)Mbps SA2: DL 2x110 (220)Mbps, UL 2x14 (28)Mbps 2x10MHz: SA1: DL 2x40 (80)Mbps, UL 2x14 (28)Mbps SA2: DL 2x55 (110)Mbps, UL 2x7 (14)Mbps Peak Rate ... -
Page 6: Environment Specification
1.4.4 Environment Specification Item Description Operating Temperature -40° C to 55° C Storage Temperature -50° C to 65° C Humidity 5% to 95% Atmospheric Pressure 70 kPa to 106 kPa Ingress Protection Rating IP66 Differential mode: ± 10KA Power Interface Lightning Protection Common mode: ±... -
Page 7: Installation
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 40cm between the radiator & your body. 2. Installation Install on Pole The position of the eNB on the pole should be at least 47 inches (120 cm) in height. After installation, adjust the eNB to a proper angle by adjusting the adjustable bracket. -
Page 8: Connect Cables
Connect Cables Power on the eNB, and wait a few minutes while the eNB boots up. Per the previous Table 1-1 and Table 1-2 in “1.3 Appearance”, check that the LED indicators are lighting as expected.