Table of Contents
Advertisement
Nova430e Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide
Go to BTS Setting > Carrier Setting to configure Carrier Mode. Click the arrow to view the drop-down menu.
NOTE: Whenever you change the carrier setting, you must reboot the eNB for the change to take
effect.
Figure 3-26: Carrier Setting
3.7.8 Reboot
Once the basic configuration settings are saved, reboot the eNB. There are two options for rebooting in
the eNB GUI. From the landing page of the eNB GUI, navigate to System > Reboot, or select Reboot under
the Welcome banner (Figure 3-27 ).
Figure 3-27: Reboot
39
Advertisement
Table of Contents
