Figure 3-22: Lgw = Router - Baicells Nova430e Installation Manual

Nova430e Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide
Field Name
IPV6 Switch
Static Address
First Address
Last Address
IMSI to IP Binding - IMSI
IMSI to IP Binding - IP

Figure 3-22: LGW = Router

3.7.4.3 Static Routing
When using static routing, go to Network > Static Routing. The Network > Static Routing landing page
has two main sections, Static Routing Config tab and Validated Route List tab (Figure 3-23). The
configured static route information is displayed under Static Routing Config tab.
To add a new static routing address to the list, click on the Add icon
OK. Once created, you can enable/disable the address. To edit an existing static routing setting, click on
the Edit icon , modify the information, and then save. Use the Delete icon
static route setting. Field descriptions are in Table 3-3.
Description
The IPV6 network interface is used for in-band connectivity with the switch, as
ON and OFF.
If LGW Mode = Router (Figure 3-22), set it to ON if you want to use a static IP
address.
If LGW Mode = Router and Static Address = ON (Figure 3-22), enter the first static
IP address in the range.
If LGW Mode = Router and Static Address = ON (Figure 3-22), enter the last static
IP address in the range.
If LGW Mode = Router and Static Address = ON (Figure 3-22), if you want to bind
an IMSI number to the IP address, enter the IMSI number.
If LGW Mode = Router and Static Address = ON (Figure 3-22), enter the IP address
to bind to the IMSI. You can add more than one IP address.
33
, enter the information, and select
to remove an existing