Table of Contents
Advertisement
Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
3.3 Install eNB on Pole or Wall
3.3.1 Install on Pole
The eNB mounting bracket is assembled in manufacturing before packing. The only action required
by the installer is to attach the assembly to the pole.
Check to ensure the diameter of the pole is in the range of 1.6–3.9 in (41–99 mm). The position of
the eNB on the pole should be at least 47 in (120 cm) in height. Follow the steps below to install
the Nova846 eNB on a pole.
1. Take apart two clamps from the assembled bracket (Figure 3-4).
Figure 3-4: Omega Clamps
2. Attach the bracket to the pole, considering the height requirements described above. Fit
the threaded rod of the bracket to the pole, and then turn the two clamps to the proper
position as shown in Figure 3-5. Fasten the four hex nuts with a wrench.
NOTE: Ensure the sequence of flat washers, spring washers, and hex nuts is the same as
the original assembly.
Figure 3-5: Attach Bracket to Pole
17
Advertisement
Table of Contents
