Nova430e Outdoor 4x250mW Two-Carrier TDD eNodeB Installation Guide
Figure 3-25: Quick Setting
3.7.7 Configure Carrier Setting
Reference:
Carrier Aggregation and Dual Carrier/Split Mode Configuration Guide
The BTS Setting > Carrier Setting sub-menu (Figure 3-26) is used in eNBs running BaiBLQ software to enable
a desired carrier mode setting. You can set the eNB to run as a single carrier, as two combined carriers
using carrier aggregation, or as two independent carriers using dual carrier, depending on which licenses
you have purchased. Single carrier (no CA) means only Cell 1 will operate and use only two RF ports instead
of four. Operators may need to use this mode if they have limited spectrum or are planning to change to
CA or DC mode at a later time when more capacity is needed for the coverage area.
38