Meiko UPster H 500 M2 Original Operating Instructions page 36

8.6 Regeneration of the built-in water softener
8.7 Changing water
36 / 56
The ActiveClean water softener automatically regenerates itself without interven-
tion by the operator.
The control light shows the ongoing regeneration (duration: approx. 8 minutes).
The dishwasher can be used for a programme run as normal. If a second pro-
gramme run is started during the regeneration time, the wash time is lengthened
until regeneration is completed. Then the pause for draining and fresh water rinse
follow.
Regeneration can be started manually, if necessary, see page 43.
A water change programme can be assigned to the wash programme keys. In the
standard setting, the water change programme is stored at the wash programme key
III (if present).
The dishwasher washes normally and empties the tank. The fresh water final rinse
follows. The water from the fresh water final rinse is already used for refilling the
wash tank. The control light above the wash key goes out.
The following options now exist:
•
Open hood, remove rack, close hood.
Machine is made ready for operation.
•
Press wash program key I or II.
Machine is made ready for operation.
•
Open hood, remove rack, close hood and press wash key.
Machine is made ready for operation and the wash programme is started.
•
Press the on/off key and then the wash key.
The self-cleaning programme is started in order to take the dishwasher subse-
quently out of operation.
9760413