Meiko UPster H 500 M2 Original Operating Instructions page 24

6.3 Perform assembly
24 / 56
Warning
Danger of injury due to machine tipping
If machine is freestanding and not secured, it could fall over and cause crushing.
•
If machine if freestanding, it must be secured long term to prevent tipping.
•
Wear protective gloves and safety shoes.
Beware
Improper fresh water connection
Backsiphonage of non drinking water into the water supply system
•
Have the fresh water connected by a qualified professional and in accordance
with local regulations.
Caution
Material damage due to ingress of pressurised media
•
Shut off the fresh water supply at the main valve prior to installation works.
•
Check that all lines are securely connected.
Caution
Material damage due to escaping steam
Small quantities of steam may escape through the dishwashing machine's hood
area. It is possible that adjacent furniture may warp.
•
Protect adjacent furniture from warping.
•
If possible, avoid installing the machine in an area close to furniture susceptible
to warping.
Note
When installing non-MEIKO tables on the hood type machine, ensure that no risks
arise at the joint with the hood, such as danger of crushing or shearing.
Notice
Assembly may be performed only by an authorised service technician.
•
Assembly must be carried out in accordance with the installation drawing.
•
Machine is intended for installation in front of a wall.
– Otherwise, the machine must be secured against tipping.
– A screw-on base is available for freestanding installation.
•
Machine is intended for installation with table installation.
•
Ensure the machine is level in both directions by using a spirit level.
•
Compensate for an uneven floor by adjusting the feet.
•
Table joints must be sealed with a detergent-resistant sealant (e.g. silicone).
•
Check that the machine is stable.
Disposal of packaging materials, see chapter "Dismantling and disposal" on
page 50!
9760413