Removing The Tpm - Fujitsu PRIMERGY CX2550 M6 Upgrade And Maintenance Manual

▶ Set the TPM Support setting to Enabled.
▶ Under Pending TPM operation, select the desired TPM operation mode.
▶ Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
10.4.3

Removing the TPM

Field Replaceable Unit
(FRU)
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Bit screw driver
– TPM bit insert
(*)
For Japan:
– TPM module fixing tool (S26361-F3552-L909)
Preliminary steps
Preliminary steps are not necessary, if a system board has to be
replaced and the TPM is used again.
▶ Before removing the TPM board, remove the BitLocker protection and
decrypt the volume, see
volume" on page
▶ Disable the TPM in the system board BIOS, see
system board BIOS" on page
▶ If applicable,
"Suspending BitLocker functionality" on page
▶
"Disabling the boot watchdog" on page
▶ Locate the desired server node with the ID button.
▶
"Shutting down the server node" on page
(*)
"Removing BitLocker protection and decrypting the
228.
229.
Upgrade and Maintenance Manual
System board and components
Hardware: 60 minutes
Software: 5 minutes
"Disabling the TPM in the
62.
45.
61.
227