Enabling Replaced Components In The Bios - Fujitsu PRIMERGY CX2550 M6 Upgrade And Maintenance Manual

Basic software procedures
Enabling the boot watchdog using the iRMC S5 web interface
▶ Log in to the iRMC S5 web interface.
▶ Select the Settings menu.
▶ Open the Server Management page.
▶ In the Boot Watchdog group, check the Enable Boot Watchdog option.
The Enable Boot Watchdog option must be selected.
▶ Select Reset from the Watchdog Action list.
▶ Click Apply for the changes to take effect.
For more information on iRMC settings, see the iRMC user guides.
5.2.6

Enabling replaced components in the BIOS

When a CPU, an expansion card, or a memory module fails, the defective
component will be set to Disabled or Failed in the BIOS. The server will then
reboot with only the intact hardware components remaining in the system
configuration.
When CPUs and DIMMs set to Failed are replaced, they are automatically set
to Enabled during the next POST except the following two situations:
● Communication between BIOS and iRMC temporarily failed during the
POST.
● Booting to execute iRMC Emergency Flash.
In this cases, the defective component needs to be reenabled in the BIOS after
replacing it.
▶ Enter the BIOS.
▶ Select the Configuration menu.
74 Upgrade and Maintenance Manual