Table of Contents
Advertisement
Expansion cards and OCP mezzanine cards
Installing an expansion card
▶ If applicable, install a slot bracket on the new expansion card, see
"Installing slot brackets" on page
▶ Install the new expansion card, see
riser module" on page
▶ In case of installing a TFM on the expansion card, see
on page
147.
▶ If applicable, reinstall SFP+ transceiver modules on the new expansion
card, see
"Installing SFP+ transceiver modules" on page
Connecting cables to the expansion card
▶ If applicable, connect internal cables to the expansion card.
For a complete cabling overview, see
Concluding steps
▶
"Installing a riser module" on page
▶
"Installing the CX2550 M6 or CX2560 M6 server node" on page
▶ Reconnect all external cables.
▶
"Enabling replaced components in the BIOS" on page
▶
"Enabling the boot watchdog" on page
▶ If applicable,
"Updating expansion card firmware" on page
▶ If applicable,
"After replacing or upgrading LAN controllers" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page
80.
▶ Inform the customer about changed WWN and MAC addresses. For further
information, see
page
83.
By replacing expansion cards WWN (World Wide Name) and MAC
(Media Access Control) addresses will change.
122
96.
116.
"Looking for MAC/WWN/GUID and SAS addresses" on
Upgrade and Maintenance Manual
"Installing an expansion card to the
"Cabling" on page
51.
73.
"Installing the TFM"
105.
265.
57.
74.
70.
88.
Advertisement
Table of Contents
