2.4
Tools you need at hand
When preparing the maintenance task, ensure that all required tools are
available. You will find a list of required tools at the beginning of each
procedure.
Screw driver /
Bit insert
Phillips PH2 /
(+) No.2
Phillips PH2 /
(+) No.2
hexagonal cross
SW5
Torx T30 driver
Torx T6 driver
Phillips PH1 /
(+) No.1
Phillips PH2 /
(+) No.2
Table 2: List of required tools and used screws for the server nodes
2.5
Documentation overview
2.5.1
Downloading manuals
Maintenance procedures may include references to additional documentation.
Screw
Upgrade and Maintenance Manual
Usage
Node link bar
Riser Module
Riser card
LC-Kit
Riser card
System Board
Riser module
CPU heat sink
LC-Kit
OCP faceplate for LAN
OCP faceplate
Bracket for Riser card
Before you start
Type
#6-32
0.9 Nm
M3 x 5.5 mm
0.6 Nm
0.9 Nm
0.6 Nm
23