Assembly Instructions - Oneida Air Systems XXVM001500 Owner's Manual

assembly Instructions

Before you start, determine which direction you want your filter to hang and which direction

you want your duct work to enter the collector. The fan housing and cyclone barrel bolt holes
are drilled at 45 degree increments; Some orientations are not possible.
Tip: The collector will seem quieter if the outlet is aimed away from primary work area.

COrreCT
Assemble the supplied support for your
1
system. Refer to the instruction sheet(s)
included with your chosen support:
• Stand Instruction Sheet # ZBI000018
[FIG 1a]
• Leg Extension Instruction Sheet #
ZBI000013
• Wall Bracket Instruction Sheet and
Template # ZBI010018A and ZBT010018
[FIG 1b]
14 Oneida Air Systems

INLeT
INLeT
COrreCT
INLeT
FIG. 1a

InCOrreCT
Filter will
obstruct
inlet pipe
FIG. 1b