Oneida Air Systems XXVM001500 Owner's Manual page 22

assembly Instructions (Continued)
Attach the flat top of the Plenum Support
10
Brace (G3) to the lower outer corner of the
Fan Housing (B) and Filter Plenum Elbow
(I1). Secure with one Flange Bolt (G4D) and
one Whiz-Lock Nut (G4E). [FIG. 10]
Install other end of the Support Brace (G3) to
11
the flange of the Barrel (C) using the hardware
installed in Step 5. [FIG. 11] Tighten all
hardware on the flange that was previously
loosely tightened.
Note: Tighten bolts until snug but not so tightly
that the gasket extrudes outside the flange.
20 Oneida Air Systems
FIG. 10
FIG. 11