Assembly Instructions - Oneida Air Systems 8491685 Owner's Manual

Assembly Instructions

Before you start, determine which direction you want your filter to hang and which direction
you want your duct work to enter the collector. The fan housing and cyclone barrel bolt holes
are drilled at 45 degree increments. Some orientations are not possible.
Tip: Aim the dust collector's outlet away from the area where people tend to work to reduce noise.
CORRECT
Assemble the Stand (P) [FIG 1]. Refer to the
1
instruction sheet included:
• Stand Instruction Sheet
# ZBI282321
8 Oneida Air Systems
INLET
INLET
CORRECT
INLET
INCORRECT
Filter will
obstruct
inlet pipe
FIG. 1