Oneida Air Systems XXVM001500 Owner's Manual page 26

assembly Instructions (Continued)
Statically ground the Drum (F) by attaching
17
the 14" Grounding Cable (G4H); Drive the
3/8" Self-Tapping Screw through its eyelet and
into the bottom of the Cone (D) just above
the installed Flex Hose (G2). Repeat using the
second 3/8" Self-Tapping Screw on the Lid's
Collared Inlet (E) [FIG. 17].
Note: If you need to extend the wire, you can
use any 16 gauge copper stranded wire and
connect with wire nuts
ENSURE THAT All ElECTRICAl poWER To THE SYSTEM IS DISCoNNECTED BEFoRE

pRoCEEDING WITH FURTHER STEpS.
Use the adhesive of your choice to temporarily
18
secure the Magnetic Starter (A1) to the wall
[FIG. 18].
To permanently secure the starter to the wall
proceed to step 19.
24 Oneida Air Systems
G4H
G2
FIG. 17
FIG. 17
FIG. 18
D
E