Oneida Air Systems XXVM001500 Owner's Manual page 25

assembly Instructions (Continued)

The flex hose connects the cyclone to the dust bin below and only requires enough height to
allow the lid to be lifted from the bin. You may shorten the provided 1' hose length as needed.
Attach Hose (G2) to the Cone's (D) discharge,
16
and secure it in place with the Clamp Band
(G1). [FIG. 16]
Note: The hose is a snug fit. Pull ends up little
by little to work the hose onto the cyclone's
discharge. Pliers can be used to grab the
reinforcing wire and aid in pulling the hose over
the opening.
Position the Drum (F) under the Cone and
repeat the process to attach the opposite end of
the Hose onto the drum's collared inlet.
Unclamp the Drum Lid (E) and test to see if
the Drum is easy to remove from underneath
the Cone.
If there is insufficient clearance for removing
the drum, you may trim the Hose using a
razor knife and diagonal cutter to cut through
the clear lining and reinforcing wire.
Note: Be careful to only remove 0.5" at a time so
as not to over trim.
D
G1
G2
E
F
FIG. 16
oneida-air.com 23