Summary of Contents for Oneida Air Systems Mini GORILLA XXP010101
Page 1
XXP010100 U.S. Design Patent 1-10 No. D604,464 Shown with optional Mobile Cart and 17 Gal. Drum. May vary slightly in appearance. Owner’s Manual Oneida Air Systems, Inc. 1001 West Fayette St., Syracuse, NY 13204 Phone 1.800.732.4065 315.476.5151 Fax 315.476.5044 www.oneida-air.com...
Thank You for Choosing an Oneida Air Systems Product! OAS manufactures and sells dust collection equipment only. Our qualified technicians and sales staff are available 8:30am - 6:00pm EST Mon. - Thurs. and 8:30am - 5:00pm EST Fri. to answer any questions concerning OAS products and dust collection.
I. System Start-Up Information 1. Read the installation and maintenance instructions as well as the recommended safety practices in this manual. 2. Have Dust Bin in place and sealed before running collector. Caution The Dust Collector & Fan is heavy! Handling and installation should always be performed by healthy individuals.
II. General Specifications 1hp Standard Mini Dust Gorilla System - 1.5hp Mini Dust Gorilla System - XXP010101 XXP010100 600 cfm 600 cfm Industrial Baldor TEFC 1.5hp motor Industrial TEFC 1hp motor 110 / 230v - 16 / 8 amps / 1.15 Service Factor 115v - 9.6 amps / 1.15 Service Factor 5”...
VI. General Assembly Instructions Assembly Instructions for Wall Bracket 12.5” 1. Before you attach the wall bracket to the wall, you must determine the proper height the collector has to be hung at. This height will be determined by the height of the dust drum you are using.
Page 8
Assembly Instructions for Motor and Cyclone 3. Attach the Magnetic Starter to a leg with supplied clamps with bolts if you have the mobile cart or a sturdy surface if you are wall mounting it. To attach motor to cyclone. 4.
Page 9
Assembly Instructions with the Mobile Cart 3. Put end cap on axle then put on wheel / washer / through the eye bolt / washer then through the tubes on the bottom of the tray as shown in diagram below, then repeat on the 1.
VII. Fan Motor Maintenance - for 1.5hp Industrial Motor only Per Baldor specifications, their 2 pole motors (3600 RPM) motors are to be relubricated every 5500 hours. Procedure Clean the grease fitting (or area around grease hole, if equipped with slot- ted grease screws).
Note: If you continue Motor Overheating to experience difficulty with your collector, call The motor’s internal circuit breaker will trip if the motor is overheating. Oneida Air Systems at Motor amperage too high - Shut system down. 1.800.732.4065 for assis- Caused By: tance.
Page 12
IX. General Safety Recommendations - Read Before Installing and Operating. Oneida Collectors are designed for WOOD Dust only!! Wood shaping and cutting processes generate wood chips, shavings and dust. These materials are considered combustible. Air- borne wood dust below 420 microns in size (.017 of an inch) in certain concentration ranges when ignited can deflagrate (burn quickly). An ignition source such as a spark, or ember, can ignite a dust mixture resulting in an expanding flame front, which can cause an explo- sion if tightly contained.
In no event shall OAS’s liability under this warranty exceed the purchase price paid for the product and any legal actions brought against Oneida Air Systems shall be tried in the State of New York, County of Onondaga.