Oneida Air Systems XXVM001500 Owner's Manual page 17

assembly Instructions (Continued)
Apply Gasket (G4A) making sure that there is
2
no gap where the ends meet:
a. Apply to the top rim of the Barrel (C)
outside of the bolt holes [FIG. 2a].
b. Apply to the Fan Housing (B) outlet inside
the bolt holes [FIG. 2b].
c. Apply to the top of the Fan Housing (B)
outside the bolt holes [FIG. 2c].
d. Apply to the Filter Plate (I2); it may
partially cover the bolt holes. Make sure
that there is enough room for the bolts to
push through [FIG. 2d].
Note: Dust collection systems cannot operate
effectively if there isn't a complete seal. There
must be NO air leaks.
Apply Gasket (G4B) to the top flange of the
3
Cone (D) inside the bolt holes making sure
that there is no gap where the ends meet [FIG.
3].
Note: Dust collection systems cannot operate
effectively if there isn't a complete seal. There
must be NO air leaks.
Top View
FIG. 2a
Top View
FIG. 2c
G4B
FIG. 3
FIG. 2b
G4A
FIG. 2d
oneida-air.com 15