General Assembly Instructions - Oneida Air Systems Dust Cobra XCK010000 A Owner's Manual

VI. General Assembly Instructions
1. Put self-sticking 1/2" x 1/4" gasket material
(RGZ025050) around inside rim on top of cyclone as
shown in photos. Be sure ends meet evenly and there is
no gap for air leakage.
2. Line up Hook clamp (AFL000003) holes in front of cone
and put the two plastic spacers (BBS025050) between
the latch and cone. Fasten with two pan head 3/4" screws
(AFS103275) using two Nylock nuts on the inside of cone.
3. Attach the self-sticking 1/4" x 1/8" gasket material
(RGZ125250) around the inlet hole in the drum lid (as
shown by dotted line), inside the bolt holes, making sure
that the ends are butted together with a slight overlap with
no gaps for air leaks. This is extremely important.
Dust Cobra Owner's Manual
c
Spacer
Spacer
Bin Level
Sensor hole
O.A.S. 2010
Tools required:
Wrenches - 3/8" / (2) 7/16" / 1/2" / 7/8"
Phillips head screwdriver
4. Put a foam handle grip (RBH000001) on wire brace
(RBB000001) as shown in Fig. 1, then pull the other side
out to slide the grip on being careful not to bend the brace
out of its pre-formed shape. Repeat with other brace.
Fig. 1
5. Fasten cyclone cone on to dust drum top using (6) hex
head 3/4" bolts (AFS015920) by putting a bolt through
a 1/4" flat washer (AFW025000) then through the drum
top. then through another 1/4" washer then fasten with a
1/4" whiz lock nut (AFT000005). The Cobra inlet must be
on the opposite side of the Bin Level Sensor hole in the
drum top.
6. Attach the side braces (RBB000001) to the cyclone
making sure the bottom bolt loops on the brace are point-
ing towards the cyclone as shown in Fig. 2.
Fig. 2
Small
Rubber
Washer
2" Bolt
First attach the top of the brace
to the cyclone by using a 2" x
5/16" bolt (AFS156200), rub-
ber washer (AFW180516) , felt
washer (AFW380125), 5/16"
flat washer (AFW180000) in the
sequence shown in the diagram
below..
Felt
Washer
Cone
Brace
Thumb Nut
5/16" Washer
7