Oneida Air Systems XXVM001500 Owner's Manual page 27

assembly Instructions (Continued)
To permanently secure the Magnetic Starter
19
(A1) to the wall. Remove the Magnetic
Starter cover by loosening the top and bottom
screws and exposing the overload and contact
connections [FIG 19a]. Set aside the screws.
a. Place a mark through the two mounting
holes [FIG 19b].
b. Use appropriate fasteners for the wall type
you are installing your system onto.
c. Drill into the wall at the marked locations.
d. Secure the Magnetic Starter to the wall.
Reattach the cover with the screws set aside in
20
Step 19 [FIG 20].
To install the Dust Sentry (M) refer to the
21
included instruction sheet:
• Dust Sentry Sheet #ZBI000002A
Top
Screw
Bottom
Screw
FIG. 19a
FIG. 20
FIG. 21
oneida-air.com
Mounting
Hole
Mounting
Hole
FIG. 19b
25