Assembly Instructions - Oneida Air Systems XCKM013000 Owner's Manual

assembly Instructions

you will need the following tools:
gENER Al
#2 Phillips Head Screwdriver
3/8" Wrench
5/16" Wrench
Insert the Handle Gasket (F5) into the
1
Handle's opening (open, ribbed-side facing
upwards) and push it onto the Stand Body's
handle (D) so that it is fully covering the top
edge [FIG. 1a].
The Handle Gasket should be nested within
the divots on each side of the Handle [FIG.
1b]. Repeat for both Handles.
12 Oneida Air Systems, Inc.
7/16" Wrench
7/16" Socket Wrench
1/2" Wrench
1/2" Socket Wrench
Utility Knife
STAND
Channel Lock Pliers
Power Drill
Drill Bit
FIG. 1a
Divots
FIG. 1b