Siemens SIMATIC ET 200AL System Manual page 492

Parameters/address space
4.2 Parameters
Parameters
Interference fre-
quency suppression
Short-circuit to
ground channel n
Wire break channel n •
Diagnostics:
Overflow/underflow
Diagnostics:
Underflow channel n
Diagnostics:
Overflow channel n
Hardware interrupt
high limit 1 channel n
Hardware interrupt
low limit 1 channel n
Hardware interrupt
high limit 2 channel n
Hardware interrupt
low limit 2 channel n
High limit 1 channel
n
Low limit 1 channel n
High limit 2 channel
n
Low limit 2 channel n
Note
Unused channels
"Deactivate" unused inputs in the parameter assignment to shorten the cycle time of the
module.
A deactivated input always returns the value 7FFF
22
Value range
3600 Hz
•
60 Hz
•
50 Hz
•
16.67 Hz
•
Disable
•
Enable
•
Disable
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
The value range depends on the meas-
urement type.
The value range (min./max.) permitted for
the measurement type is listed in the
table below.
Analog input module AI 4xU/I/RTD 4xM12 (6ES7144-5KD00-0BA0)
Default GSD file
PROFINET IO
50 Hz Channel
Disable Channel
Disable Channel
Disable ---
Disable Channel
Disable Channel
Disable Channel
Disable Channel
Disable Channel
Disable Channel
Channel
Channel
Channel
Channel
.
H
Manual, 03/2016, A5E32350124-AC
GSD file
PROFIBUS DP
Module
Channel
Channel
Module
---
---
---
---
---
---
---
---
---
---