Siemens SIMATIC ET 200AL System Manual page 163

Parameters
4.1 Parameters
The following table shows the parameters for the IM 157-1 DP interface module.
Table 4- 1
Parameters
Configuration control
Startup if preset configuration does
not match actual configuration
Diagnostics interrupt
Hardware interrupt
Pull/plug module interrupt
Note that the "Startup if preset configuration does not match actual configuration" parameter is
1
always activated when you use configuration control.
The defaults apply to the default startup. If no other parameters are specified by the DP master,
2
the interface moduleIM 157-1 DP starts up with these parameters.
20
Parameters
1
Value range Default
Disable
Disable
•
Enable
•
Disable
Disable
•
Enable
•
Enable
Disable
•
Enable
•
Enable
Disable
•
Enable
•
Enable
Disable
•
Enable
•
Interface module IM 157-1 DP (6ES7157-1AA00-0AB0)
Efficiency range
2
ET 200AL
ET 200AL
ET 200AL
ET 200AL
ET 200AL
Manual, 12/2016, A5E32100641-AD
4