Siemens SIMATIC ET 200AL System Manual page 47

5.7.2 Optional markings
Introduction
In addition to the factory markings, there are also optional possibilities for labeling and/or
identifying interfaces and modules on the ET 200AL distributed I/O system.
Identification label
The identification labels come with each module as strips and can be machine-printed. A
strip has 10 identification labels measuring 10 x 5 mm in the color RAL9016. The
identification labels can be inserted into every module at the points provided. The
identification labels are used for channel, module and slot labeling.
The figure below shows all points where you can use the identification labels using the
example of the IO-Link Master CM 4xIO-Link 4xM12 communication module.
①
Figure 5-11
5.7.3 Mounting identification labels
Introduction
This section describes how to mount or remove identification labels.
Distributed I/O system
System Manual, 02/2018, A5E31861578-AF
Identification labels
Optional marking
Connecting
5.7 ET 200AL marking
45