Sntp Client Enable (Interface) - TP-Link TL-SG3109 Cli Reference Manual

sntp client enable (Interface)

The sntp client enable Interface Configuration (Ethernet, port-channel, VLAN) mode command enables the Sim-
ple Network Time Protocol (SNTP) client on an interface. This applies to both receive broadcast and anycast
updates. To disable the SNTP client, use the no form of this command.
Syntax
sntp client enable
no sntp client enable
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Interface configuration (Ethernet, port-channel, VLAN) mode
User Guidelines
Use the sntp broadcast client enable Global Configuration mode command to enable broadcast clients globally.
Use the sntp anycast client enable Global Configuration mode command to enable anycast clients globally.
Examples
The following example enables the SNTP client on Ethernet port 3.
Console(config)# interface ethernet e3
Console(config-if)# sntp client enable
TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
Page 58