Enable Password - TP-Link TL-SG3109 Cli Reference Manual

TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide

enable password

The enable password Global Configuration mode command sets a local password to control access to user and
privilege levels. To remove the password requirement, use the no form of this command.
Syntax
enable password [level level] password [encrypted]
no enable password [level level]
Parameters
•
password — Password for this level (Range: 1-159 characters).
•
level — Level for which the password applies. If not specified the level is 15
(Range: 1-15).
•
encrypted — Encrypted password entered, copied from another device configuration.
Default Configuration
No enable password is defined.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets local level 15 password secret to control access to user and privilege levels.
Console(config)# enable password level 15 secret
Page 27