Channel-Group - TP-Link TL-SG3109 Cli Reference Manual

TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide

channel-group

The channel-group Interface Configuration (Ethernet) mode command associates a port with a port-channel. To
remove a port from a port-channel, use the no form of this command.
Syntax
channel-group port-channel-number mode {on | auto}
no channel-group
Parameters
•
port-channel_number — Specifies the number of the valid port-channel for the current port to join.
•
on — Forces the port to join a channel without an LACP operation.
•
auto — Allows the port to join a channel as a result of an LACP operation.
Default Configuration
The port is not assigned to a port-channel.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example forces port 1 to join port-channel 1 without an LACP operation.
Console(config)# interface ethernet e1
Console(config-if)# channel-group 1 mode on
Page 155