TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode command configures the maxi-
mum broadcast rate. To return to the default configuration, use the no form of this command.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
•
rate — Maximum kilobits per second of broadcast and multicast traffic on a port
Possible values are:
–
70K - 1M in steps of at least 10K
–
1M-10M in steps of at least 1M
–
10M-250M in steps based on the requested rate
Default Configuration
The default storm control broadcast rate is 100 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast enable Interface Configuration mode command to enable broadcast
storm control.
Since granularity depends on the requested rate, the software displays the actual rate.
Example
The following example configures the maximum storm control broadcast rate at 900 Kbits/Sec on Ethernet
port 5.
Console(config)# interface ethernet e5
Console(config-if)# port storm-control broadcast rate 900
Page 95