Deny (Management) - TP-Link TL-SG3109 Cli Reference Manual

TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family CLI Reference Guide

deny (Management)

The deny Management Access-List Configuration mode command defines a deny rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel port-channel-number]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel
port-channel-number]
Parameters
•
interface-number — A valid Ethernet port number.
•
vlan-id — A valid VLAN number.
•
port-channel-number — A valid port-channel number.
•
ip-address — A valid source IP address.
•
mask — A valid network mask of the source IP address.
•
mask prefix-length — Specifies the number of bits that comprise the source IP address prefix. The prefix
length must be preceded by a forward slash (/). (Range: 0-32)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the appropri-
ate interface.
The system supports up to 128 management access rules.
Example
The following example denies all ports in the access list called mlist.
Console(config)# management access-list mlist
Console(config-macl)# deny
Page 145